Page 1 of 1
Feature Request: Halt on Error
Posted: Wed Sep 17, 2014 6:31 pm
by Dirkmaster
I mentioned this in a post above, but it might not have been the right place. If so, apologies. I would like an option that would allow the conversion process to halt if there is an encoding error. I cannot always be looking at the window to see the red "bang", which additionally goes away when the process is complete. I don't want to have to go thru the log file, expanding again and again, to see if the files encoded correctly. This is especially important if you are burning discs directly.
Just a simple check box to "Halt on Error" that would stop the encoding process if an encoding error occurs.
thanx
Dirkmaster
Re: Feature Request: Halt on Error
Posted: Wed Sep 17, 2014 7:26 pm
by cedric
Re: Feature Request: Halt on Error
Posted: Wed Sep 17, 2014 7:34 pm
by Dirkmaster
Really? Great. Ahhhh, where is it? I can't find it in options in Version 1.4.0.22.
And it just kept right on going when a file failed just now, so it must not be on by default. And I can't find it to turn in on. :cry:
Can you give me a hint as to where it is?
Or did you mean it would be in the NEXT full release, and I just misunderstood.
Oh, and thanx for load/save project, btw. Thats a big help too.
DIrkmaster
Re: Feature Request: Halt on Error
Posted: Wed Sep 17, 2014 7:58 pm
by cedric
Your suggestion has been implemented in last official version 1.5.0.0 released today:
http://www.vso-software.fr/products/vid ... verter.php
You will found this setting under conversion section.
Regards,
Re: Feature Request: Halt on Error
Posted: Wed Sep 17, 2014 8:04 pm
by Dirkmaster
Out -f'ing-standing! Thanx a ton. That may be the quickest implementation EVER.
I hadn't seen the notice of the new version, so thanx for that as well.
You are the best. <tip of the hat>